Rotary feeder, commonly known as shut-off fan, unloader, rotary feeding valve, rotary unloading valve, rotary valve, etc., is the main conveying equipment of bulk materials. With the advantages of strong reliability and affordable price, it is widely used in grain processing, chemical raw materials, plastic metallurgy, energy mining, building materials, cement and other industries. During the use of this product, in order to ensure the stability of operation, there are some matters that need to be paid attention to. Let's share the operation requirements of this equipment.

1、供料器應按規定的方法安裝在固定的基礎上，移動式供料器正式運行前應先將輪子用三角木楔住或用制動器剎住，以免工作中產生移動；

1. The feeder shall be installed on a fixed foundation according to the specified method. Before the formal operation of the mobile feeder, the wheels shall be wedged with triangular wood or braked with brakes to avoid movement during operation;

2、皮帶打滑時不可用手去拉動皮帶，以免發生事故；

2. Do not pull the belt by hand when the belt slips to avoid accidents;

3、運行出現膠帶跑偏現象時，應停機調整，不得強行使用，以免磨損邊緣和增加負荷；

3. In case of belt deviation during operation, stop the machine for adjustment and do not use it forcibly to avoid wearing the edge and increasing the load;

4、皮帶供料器應空載啟動，等運轉正常后方可入料，千萬不能先入料后啟動；

4. The belt feeder shall be started without load and can be fed only after normal operation. It must not be started after feeding first;

5、不得輸送酸堿性的油類和溶劑成份的物料；

5. Do not transport acid-base oils and materials with solvent components;

6、旋轉供料器使用前須檢查各運轉部分、膠帶搭扣和承載裝置是否正常，防護設備是否全；

6. Before using the rotary feeder, check whether the operating parts, belt buckles and bearing devices are normal and whether the protective equipment is complete;

7、膠帶的漲緊度須在啟動前調整到合適的程度；

7. The tension of the tape must be adjusted to an appropriate degree before starting;

8、有數臺供料器串聯運行時，應從卸料端開始，按順序起動，正常運轉后，方可入料；

8. When several feeders operate in series, they should start from the discharge end and start in sequence. After normal operation, they can be fed;

9、工作環境及被送物料溫度不得高于50攝氏度和低于零下十?dāng)z氏度；

9. The working environment and the temperature of the delivered materials shall not be higher than 50 ° C and lower than minus 10 ° C;

10、輸送帶上禁止行人或乘人；

10. No pedestrians or passengers are allowed on the conveyor belt;

11、有多臺供料器平行作業時，機與機、機與墻之間應有一米的通道；

11. When multiple feeders operate in parallel, there should be a one meter channel between machines and between machines and walls;

12、停機前須先停止入料，等皮帶上存料卸盡方可關停設備；

12. Before stopping the machine, the feeding must be stopped first, and the equipment can be shut down only after the materials stored on the belt are discharged;

13、旋轉供料器的電動機須絕緣良好，移動式供料器電纜不要亂拉和拖動，電動機要可靠接地。

13. The motor of rotary feeder shall be well insulated, the cable of mobile feeder shall not be pulled and dragged randomly, and the motor shall be reliably grounded.

以上就是為大家介紹的有關廣東旋轉供料器的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服務http://www.25dns.cn/

The above is about Guangdong rotary feeder. I hope it will help you If you have any questions, please contact us We will provide you with professional service http://www.25dns.cn/